This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:tinkering:laser:eleksmakera3pro [2018/01/16 16:33] alessio.cavalieri [Resources] |
en:tinkering:laser:eleksmakera3pro [2020/10/20 15:41] (current) alessio.cavalieri [Blog] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== EleksMaker EleksLaser-A3 Pro ====== | ====== EleksMaker EleksLaser-A3 Pro ====== | ||
===== Blog ===== | ===== Blog ===== | ||
+ | * 2020 october 20: added [[en:tinkering:laser:eleksmakera3pro#power_and_speed_settings|Power and speed settings ]] section | ||
* 2017 december 18: Improved the smoothness of the X carriage, $110=5000 and $111=5000 for setting the max speed to 5000 mm/min in GRBL | * 2017 december 18: Improved the smoothness of the X carriage, $110=5000 and $111=5000 for setting the max speed to 5000 mm/min in GRBL | ||
* 2017 december 13: Added smoke blower and pimped up step drivers current, heat sink installed on Allegro chip | * 2017 december 13: Added smoke blower and pimped up step drivers current, heat sink installed on Allegro chip | ||
Line 18: | Line 19: | ||
- unwear the laser protection goggles | - unwear the laser protection goggles | ||
</note> | </note> | ||
+ | ===== Power and speed settings ===== | ||
+ | ==== 2500 mW Laser Diode ==== | ||
+ | === Vector letters outline / thin outline === | ||
+ | |||
+ | ^ Material ^ Laser Power (%) ^ Passes ^ Cut rate (mm/min) ^ Example ^ | ||
+ | | Plywood | 20 | 1 | 500 | {{:en:tinkering:laser:2-5w_laser_vector_letters_outline_plywood_3mm.jpg?200|}} | | ||
+ | |||
+ | === Vector letters fill path === | ||
+ | ^ Material ^ Line Distance (mm) ^ Laser Power (%) ^ Passes ^ Cut rate (mm/min) ^ Example ^ | ||
+ | | Plywood | 0.1 | 20 | 1 | 1000 | {{:en:tinkering:laser:2-5w_laser_vector_letters_fill_path_plywood_3mm.jpg?200|}} | | ||
+ | |||
+ | === Cut === | ||
+ | ^ Material ^ Thickness (mm) ^ Laser Power (%) ^ Passes ^ Cut rate (mm/min) ^ Example ^ | ||
+ | | Plywood | 3 | 50 | 8 | 80 | {{:en:tinkering:laser:2-5w_laser_cut_plywood_3mm.jpg?200|}} | | ||
+ | |||
===== GRBL settings ===== | ===== GRBL settings ===== | ||
I'm using the machine with GRBL firmware and LaserWeb4 PC frontend instead the original EleksCAM (called somewhere Elek-SCAM 8-) ) | I'm using the machine with GRBL firmware and LaserWeb4 PC frontend instead the original EleksCAM (called somewhere Elek-SCAM 8-) ) |