en:tinkering:3dprinting:myowncreatedobjects:vacuumcleanerstorageorganizer
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
en:tinkering:3dprinting:myowncreatedobjects:vacuumcleanerstorageorganizer [2018/01/06 23:21] alessio.cavalieri [Vacuum cleaner storage organizer] |
en:tinkering:3dprinting:myowncreatedobjects:vacuumcleanerstorageorganizer [2018/01/06 23:21] alessio.cavalieri [Files] |
||
|---|---|---|---|
| Line 32: | Line 32: | ||
| vacuum_cleaner_brush_holder.stl / fcstd -> brush holder | vacuum_cleaner_brush_holder.stl / fcstd -> brush holder | ||
| - | vacuum_cleaner_brush_holder_mirror.stl / fcstd -> brush holder mirrored | + | vacuum_cleaner_brush_holder_mirror.stl -> brush holder mirrored |
| vacuum_cleaner_tube_holder.stl / fcstd -> tube holder | vacuum_cleaner_tube_holder.stl / fcstd -> tube holder | ||
en/tinkering/3dprinting/myowncreatedobjects/vacuumcleanerstorageorganizer.txt · Last modified: 2019/02/25 21:19 by alessio.cavalieri
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
